Not quite a build thread....

[Davidbolam]

Originally Posted by Johno

Hi David,
Well I'm hoping it shouldn't be too bad... I've got the 90 degree Toyota adapter on the gearbox to avoid the cable being bent too tight against the frame.
With any luck should be able to try it this week as I'm trial fitting my dash at the moment...






It's looking a bit tatty at the moment with the wrong type bolts holding the dash in place and all the masking tape still covering the GRP..

Johno,

I have got one of those 90 degree bends as well. I may have to add a small bubble so st speak to the transmission tunnel panel as it will be very close. i can see it banging all the time and not sure if the iva man would like it touching.

*** Please could you also measure the distance from the centre of the rear wheel to the front of the rear wing. I am looking at putting my exhaust in place and dont want it to interfere once the bodywork is attached.***

Thanks

David