|
|
|
|
#1
23rd July 2015, 08:42 AM
|
|||
|
|||
Thanks buddy, yeah the bearings are the correct width etc and the outer races are pressed hard up in position. It's the inner tapered race that just simply falls in place and 'wiggles' a bit. I will press the dust covers a bit further in thanks for the prompt.
Hopefully once all tightened up there is no movement (except from the required rotation of course)
__________________
Total Spent so far - £xxxxx Last Purchase - Engine mounts, steering wheel, slave cylinder. 
|
|
#2
23rd July 2015, 10:37 AM
|
|||
|
|||
|
There is a seat on the inside of the taper races that tightens together and that will give you the pre-load on the bearings.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
23rd July 2015, 10:44 AM
|
|||
|
|||
|
Cant read message at the mo Neil,problem with Haynes.
Ring garage if you need to.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
