Rosco's haynes Build

[Rosco]

Wishbones fitted



Few other bits fitted



Today's job was to get the seat panel fitted, my dad gave me a hand as it was quite tight and didn't want to scratch everything

The panel fit really well from the laser cutters and only needed a little trim on the tunnel top, then the top and bottom needed bending

We clamped the bottom Inbetween two bits of box section and the top between timber with a bevel on the back



It folded real nice

We both decided it needed bead rolling to match the rest

[Rosco]

All sealed and riveted



I decided to gob the backside with the sealer to stop any water or dirt getting trapped anywhere, not the neatest but does the job