Rosco's haynes Build

[Rosco]

I'm using these terminal bars for my wiring



Toggle switches for my dash

[Rosco]

New gear lever made





Also made a bracket for the starter relay

[SeriesLandy]

Looking spot on like normal.
I've got a dash2 as well and had problems with the Hall effect sensor picking up the diff bolts (prop side).
I would loose speed after about 20mph. I put it down to the prop spinning too fast.
I ended up putting the sensor on the half shafts and haven't had a problem yet.
It may just have been a 1 off but it was a pita to change it as I had pretty much got the car finished.
A mate also used the studs on the front front uprights but he had the other type of sensor. It also caused Problems at iva as they couldn't do the speed test as the wheels went driven

[Rosco]

Originally Posted by SeriesLandy

Looking spot on like normal.
I've got a dash2 as well and had problems with the Hall effect sensor picking up the diff bolts (prop side).
I would loose speed after about 20mph. I put it down to the prop spinning too fast.
I ended up putting the sensor on the half shafts and haven't had a problem yet.
It may just have been a 1 off but it was a pita to change it as I had pretty much got the car finished.
A mate also used the studs on the front front uprights but he had the other type of sensor. It also caused Problems at iva as they couldn't do the speed test as the wheels went driven

Cheers for that, I will have a look into it

[Rosco]

Almost two full days of wiring!

All dash wires into terminal rails



These are the ends, crimp forks soldered on



Two 13 way plugs fitted on the end of the bike loom and fly leads out the other side to the rails



Engine loom in position and getting neater

[Rosco]

Water pump removed, need to block the hole in the block, I'm going to run an electric water pump



And that's it, doesn't look a lot, got a few more plugs to fit and get my switches mounted then I will be linking the rails together, I might get rid of the rails when it's all wiried but I will see, I did it this way as its all laid out and I'm hoping it will be easy to keep track of

[norton]

Look great as always? Why the electric pump?