Steveh1's build

[Rosco]

I think i did the tunnel before i moved it forwards on the table,

[SteveH1]

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

I got the rest of the diagonals and seat back finished

[SteveH1]

Painted my vice

Untitled by stephen harborne, on Flickr

and built a bench
ive always wanted a steel bench

Untitled by stephen harborne, on Flickr

Vice on bench

Untitled by stephen harborne, on Flickr

[SteveH1]

Then i got working on on the transmission tunnel

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Most of the tunnel tacked in place

[SteveH1]

And the view from the drivers seat

Untitled by stephen harborne, on Flickr

made me a bit giddy

[SteveH1]

Got a bit done on the rear suspension this weekend

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Also got my first chassis plate cut

Untitled by stephen harborne, on Flickr

And my beautiful distraction

Untitled by stephen harborne, on Flickr

[SteveH1]

So i was given this roll bar its a standard caterham 7 bar

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

So my plan is to cut off the original mountings on the thick bar and put a flat bar plate on each end.
Then make a plate the same as cp3 and cp4 and mount them 50mm higher straight above cp3 and cp4 with nuts welded on the inside
Like build a box if this makes sense 50mm high

can anyone see a problem with this

Can i then weld 50mm box section between these boxes with the seat belt anchorage's welded into this bar