|
|
|
|
#1
20th November 2015, 05:47 AM
|
|||
|
|||
What I did was make the actual bracket longer than book and fold the ends over in a long u shape and just weld a nut on instead of tubes.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. 
|
|
#2
20th November 2015, 06:54 AM
|
|||
|
|||
|
What he is trying to say is the bracket is much stronger if can spread the load along the edge of the box section and across the top face of it as well, you then weld effectively all six sides of the bracket. Just go on ebay buy some 7/16 UNF nuts drill an 11mm hole and weld it in place, a little tip grind the plating off the faces of the nuts first.
His brackets and mine look like this....  and I promised myself I was'nt going to post any thing today.
__________________
Unofficially rated No.1 supplier of fabricated Haynes Roadster parts by the workshop rat population. Direct email talonmotorfabrication@gmail.com Last edited by TalonMotorFabrication : 20th November 2015 at 07:05 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
