|
|
|
|
#1
1st January 2016, 07:08 PM
|
|||
|
|||
Space heat foil stuck on the aluminium heat shield and bolted on
 Exhaust manifold fitted, and even if I say so myself I couldn't stop smiling after getting this all fitted up    
|
|
#2
1st January 2016, 07:09 PM
|
|||
|
|||
|
Next job Dashboard, I've been struggling with this, deciding which way to go, I didn't like the look of the equinox one, I wanted a carbon one but there's not one with an iva edge,
In the end I decided to make one with deboned sheet, easy to work with etc, as for the lower edge I'm using black pvc waste pipe, sounds crude but it's turned out sweet Template first, I used 2mm coriguated plastic from wickes, was only £4 for an 8x4 sheet and can be easily cut   Fixing holes drilled and rivnuts fitted in scuttle  Rubber grommet and sleeve for steering column 
|
|
#3
1st January 2016, 07:10 PM
|
|||
|
|||
|
I was in the zone and forgot to take any pictures, I cut all the switch and dash holes out on my dads cnc
Back of the dash  All fitted up for good hopefully, lower edge pipe trim fitted  Full photo  Battery fitted and passenger footrest, I might block the battery off from the footwell with a bit of dibond 
|
|
#4
1st January 2016, 07:10 PM
|
|||
|
|||
|
And a full shot for a change, starting to look like a car
|
|
#5
2nd January 2016, 10:46 AM
|
|||
|
|||
|
Looking good there Rosco. Must say iv been following you and it's a very good build. Wish I had a accses to CNC machines as iv had to do all mine by hand which does limit things. Looking forward to seeing it on the ground and on the road.
https://www.flickr.com/photos/124541083@N02/
|
|
#7
2nd January 2016, 03:18 PM
|
|||
|
|||
|
Quote:
Your builds sweet too, I've been looking at it on Flickr but can't seem to comment on it on the iPad, love your rear lights and did you wet lay the dash yourself? I wish I had of gone for aluminium sides, looks very smart, have you booked your iva yet? Quote:
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
