|
|
|
|
#1
24th January 2016, 10:55 PM
|
|||
|
|||
Cheers for that.
Yea im not a fan of cutting it. Would you have an expanded view showing the handbrake in relation to the gearstick Cheers
__________________
Slowly tipping over the edge into madness 
|
|
#2
28th January 2016, 08:19 PM
|
|||
|
|||
 Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on FlickrRear suspension brackets in place
__________________
Slowly tipping over the edge into madness
|
|
#3
28th January 2016, 09:17 PM
|
|||
|
|||
 heres one of the handbrake, clears the gearstick ok , could be further back by welding the cable clamp plate further back, i also welded on the small bracket that straightens the short cable into the handle, it cam off the trans tunnel of the mx5 and keeps the cable straigh and more importantly away from the prop
|
|
#5
5th February 2016, 08:07 PM
|
|||
|
|||
|
Ok so i got the front suspension brackets mounted this required a jig to be made
it was a bit fiddly but got done in the end Top jig  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#6
5th February 2016, 08:07 PM
|
|||
|
|||
|
__________________
Slowly tipping over the edge into madness
|
|
#7
5th February 2016, 08:08 PM
|
|||
|
|||
|
Brackets tacked in place
 by stephen harborne, on Flickr by stephen harborne, on FlickrAlso added a support brace  Untitled by stephen harborne, on FlickrGot these cut for the lower adjusters for the wishbones  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
