|
|
|
|
#1
20th March 2016, 05:13 PM
|
|||
|
|||
Has anyone got a link to the relay you are refering to? I have a mazda wiring loom and the indicators hyper flash. I have used load resistors which solve the indicator issue but when the hazard lights are in the side led indicators hardly light up. Any suggestions?
__________________
One day it will be on the road...... 
|
|
#2
20th March 2016, 06:28 PM
|
|||
|
|||
|
hi I used one like this as I have a mix of led / bulbs
http://www.ebay.co.uk/itm/LAND-ROVER...AOSwq5lTmNd m hth
__________________
remember we are not mad just creatively insane
|
|
#4
20th March 2016, 08:45 PM
|
|||
|
|||
|
hi I cut and shut the mx5 loom (mk2.5) as there were so many cross wires I decided it was so much easier to pick up the stalk wires and rewire from there .
I'm trying to remember how I did it but from the dim and dark recesses, and there is probably a much easier way !!!! I ran the ignition feed to the relay then to the stalk which obviously then feeds either side, I used a second relay with a permanent live feed , relay to the hazard switch (rdx has 2 sides so that the indicator signal does not cross) wired into the indicator wires. hope that makes some kind of sense, basically I have 2 circuits feeding into the indicator wiring, 1 perm live (hazards) 1 ign live (indicators) not sure how to do it if using the mx5 hazard switch. I would try replacing the indicator relay first and see what happens from there regarding the hazard function, I guess you could put a diode (one way current) in hazard to indicator wiring if you have to rewire this would stop any cross feeding when using the indicators. hth Gary
__________________
remember we are not mad just creatively insane
|
|
#5
21st March 2016, 01:23 PM
|
|||
|
|||
|
I think the rewire will be a last resort. How about this relay: http://m.ebay.co.uk/itm/Mazda-MX5-Bo...187?nav=SEARCH
Appears to be a straight swap...
__________________
One day it will be on the road......
|
|
#6
21st March 2016, 06:29 PM
|
|||
|
|||
|
yes it appears from the description that he has redone the internals so if it fits your pin layout that should solve your probs
__________________
remember we are not mad just creatively insane
|
|
#7
29th March 2016, 01:22 PM
|
|||
|
|||
|
The solution was a lot more simple then touching relays. I used a 25w load resistor on each side to stop the hyper flash and replaced the led side repeators with normal bulb indicators from CBS. Works perfect now!
__________________
One day it will be on the road......
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
