|
|
|
|
#1
25th June 2016, 10:04 PM
|
|||
|
|||
Got a bit done this week, got the canards finished and fitted, bit tricky getting both sides the same but my dad eyed them up!
  My dad made me some blacking plates so I could remove the air bypass bumf  Next job, rear diffuser, more brackets made by my dad  
|
|
#2
25th June 2016, 10:06 PM
|
|||
|
|||
|
Brackets mounted on suspension bolts
 Rough card template  1.5mm aluminium, blank canvas!  Folding back edge up 
|
|
#3
25th June 2016, 10:07 PM
|
|||
|
|||
|
Getting there
  Got to have some bead rolling  
|
|
#4
25th June 2016, 10:09 PM
|
|||
|
|||
|
Fins added, going to nut and bolt these after paint I think, that way if one gets damaged i can just replace it
  Looks a bit over the top but that's what I wanted, not bad for £15 for the aluminium sheet! 
|
|
#5
28th June 2016, 10:18 PM
|
|||
|
|||
|
Got some bonnet vents fitted, just to let some air out as there's only down the tunnel with the full floor etc
Holes cut  Stuck in  All done  
|
|
#6
28th June 2016, 10:18 PM
|
|||
|
|||
|
Also made a gopro mount
  Might get the diffuser back from paint tomorrow too! Can't wait!
|
|
#7
30th June 2016, 10:35 AM
|
|||
|
|||
|
Brilliant job as normal ! Don't know if it makes a lot of difference but splitters I have seen on cars have the center boxed in like a scoop even on boy racer ST fiesta's/ST Focus.
I have a diff/rear cover the same and will turn that into a splitter too.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
