No real plans unfortunately, I just measured up the space & went from there. It is about 7" deep, 7" wide & 14" long, ish!
I started with a flat piece of ally & cut it to size, I then cut the corners out which left me with a sort of cross shape, I then folded the sides up 90deg. I put some 90 deg angles in the cornerstone hold it all in place. The box was attached to the cover by more 90 deg angles. The cut out from the cover made the lid. I hinged mine at the back so I could open it past my roll bar.
Nothing to difficult, just plenty of planning first!! Hope this helps
|
7th September 2016, 10:22 PM
Threaded Mode