Steveh1's build

[twinturbo]

Is there some sort of gasket to fill in the space under the rolled edge of the sender top plate?

TT

[SteveH1]

Originally Posted by twinturbo

Is there some sort of gasket to fill in the space under the rolled edge of the sender top plate?

TT

Yep its just off it while i was drilling the holes.

[RandyBMC]

Just read through your whole build. Really nice fabrication work and welding! Keep it up - I'm following with interest.

[SteveH1]

Thanks a lot. Its slow going.

[SteveH1]

So ive been slowly tipping away doing a few bits and pieces
Mostly stripping and cleaning the hubs with wire brushes in the drill which is a pain
Another kit car builder dropped in last weekend and suggested electrolysis rust removal
This is something i was hoarding stuff for but was too lazy to actually do
so not long after that fella left i got cracking

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

I gave a part 6 hours and it was quiet clean which made me happy

[SteveH1]

So then i got impatient

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

And started on another bigger one

I also did a bit of filler work on the bonnet

Untitled by stephen harborne, on Flickr

[SteveH1]

So i Gave the knuckle 24 hours in the bath
And i have to say i am delighted with the results compared to the effort and time it took with the drill and wire brush

When i took it out of the bath it still had some flakey bits so i gave it a blast with the power hose to remove what was left
Then i dried it and ran over it with the wire brush
and gave it a coat of kurust
Also the process removes all the grease and grime and crap

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr