|
|
|
|
#1
1st May 2018, 09:01 PM
|
|||
|
|||
So i Gave the knuckle 24 hours in the bath
And i have to say i am delighted with the results compared to the effort and time it took with the drill and wire brush When i took it out of the bath it still had some flakey bits so i gave it a blast with the power hose to remove what was left Then i dried it and ran over it with the wire brush and gave it a coat of kurust Also the process removes all the grease and grime and crap  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness 
|
|
#2
1st May 2018, 09:04 PM
|
|||
|
|||
|
This is what it looked like before
 Untitled by stephen harborne, on Flickr2 on the go now  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#3
1st May 2018, 09:48 PM
|
|||
|
|||
|
Brilliant - welcome to the club - worked for me as well on loads of rusty bits for my build
__________________
My build blog here http://ianhaynes20.wordpress.com
|
|
#5
30th July 2018, 10:05 PM
|
|||
|
|||
|
So ive a serious pain in my face at the moment cleaning and painting and reassembling the engine
Before  Untitled by stephen harborne, on FlickrCurrent  Untitled by stephen harborne, on FlickrIm also doing a coil on plug upgrade as i had all the parts i needed so it didnt cost me anything  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness Last edited by SteveH1 : 30th July 2018 at 10:08 PM.
|
|
#6
1st August 2018, 07:17 AM
|
|||
|
|||
|
Some more progress
 Untitled by stephen harborne, on FlickrIm also going to do some kind of diy coolant reroute Havnt got it fully figured out yet  Untitled by stephen harborne, on FlickrThis part fits nicely of the back of the engine like so  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#7
6th August 2018, 08:27 PM
|
|||
|
|||
|
Finally got the engine back together mostly
 Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#8
7th August 2018, 05:34 AM
|
||||
|
||||
|
Scrubbed up nicely
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
