|
|
|
|
#2
18th September 2018, 10:25 AM
|
|||
|
|||
So ive got a bit done recently
First i built an spacer for the new rear coolant pipe for the reroute to move it out from the block  Untitled by stephen harborne, on FlickrThen i filled in the the hole in the side coolant connector  Untitled by stephen harborne, on FlickrUsed a 20 cent to stop the epoxy running into it  Untitled by stephen harborne, on FlickrFilled with epoxy  Untitled by stephen harborne, on FlickrThe hole was a feed for the interior heater so is not needed
__________________
Slowly tipping over the edge into madness 
|
|
#3
18th September 2018, 10:34 AM
|
|||
|
|||
|
This is the coolant reservoir That i got
It only has this mounting point so i made a bracket to hold the whole thing  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on FlickrI also removed the old mounting points for the heat shield from the manifold and cleaned and painted it  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#4
18th September 2018, 10:40 AM
|
|||
|
|||
|
I also started on the pedal box
 Untitled by stephen harborne, on FlickrI also mounted the ecu under the dash  Untitled by stephen harborne, on FlickrAnd made a bracket for the accelerator cable  Untitled by stephen harborne, on FlickrAnd the engine is back in  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
