|
|
|
|
#1
28th December 2018, 08:49 PM
|
|||
|
|||
Been away from the build for a while
Next on the list was too hinge the bonnet at the front So i made a steel frame for the front of the nose cone which i riveted in place the fibreglassed over to give strength  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness 
|
|
#2
28th December 2018, 08:57 PM
|
|||
|
|||
|
Bonnet now in place
 Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on FlickrBonnet in place passenger side gap to scuttle panel  Untitled by stephen harborne, on FlickrDrivers side gap This will not do  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#3
28th December 2018, 09:01 PM
|
|||
|
|||
|
Along came a grinder
 Untitled by stephen harborne, on FlickrAnd the i cleaned up a bit  Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
