|
|
|
|
#1
4th July 2020, 04:51 PM
|
||||
|
||||
The MadCod?
It's a customised speeduino board. I had one for a few months but other projects meant it was not going to get used and I sold it to fund a bit of my Modular Synth... It seemed well made and the guy behind them is very helpful. My only issue was that I loaded a new firmware not realising that their firmware is a tailored version of the speeduino code. I have spent the last 6 months soldering projects for my synth, so building a Speeduino will be childs play now.
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders 
|
|
#2
22nd July 2020, 03:20 PM
|
|||
|
|||
|
Afternoon Turbo
Madcod is that the guy that builds these ECU's? Well i have managed to get the wiring for my key reader etc so i can now wire that up and get the old girl running but i still dont want to spend near on £700 on an ECU later on (tight git) Are they any good these speeduino ECU's Cheers Gary
|
|
#3
23rd July 2020, 04:39 PM
|
|||
|
|||
|
Hi Gary if you download Speeduino, it tells you all about how to use Speeduino etc.
Also you can get full kit of parts on EBay to connect to mx5 loom etc for around £100. You can download Tunerstudio that allows you to set up the software. I built one awhile ago now, set it up temp and the car started up and ran ok, they update the software all the time and you can download it. Regards Mick.
|
|
#4
25th July 2020, 05:07 PM
|
||||
|
||||
|
race electronics will be able to help out, i think they do a plug and play mx5 version.
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
