Zetec injection question

[Bonzo]

Thanks again Adrian

I did find a small amount of info on the MS forum, mainly guestimated flow rates based on BHP produced by the original engine.

My searching was interupted buy a new search.

Trying to find the operating range of the IAC stepper motors that I have found.

When I built the Megasquirt I opted for the stepper motor idle control as opposed to the original ford type idle control unit.

I did find a couple of stepper motors in self contained units that are ideal for the job. Rover K series unit & a Renault unit.
All I have to do now is find the tec data on them.