Exhausts

[flyerncle]

The flexi stuff is a bit of a pain to weld as it's thin guage metal,bends are available locally to you Andy in Boro, pm for number.

[geeman]

Originally Posted by flyerncle

The flexi stuff is a bit of a pain to weld as it's thin guage metal,bends are available locally to you Andy in Boro, pm for number.

im glad ive got a tig that goes down to 20 amps, so welding thin stuff aint a problem, im just wondering, do you know how flexible it actually is, as in would it be easy to do a 90+degree bend in.

[mark]

I could be wrong geeman the flexi pipes that i have personally seen would not be capable of bending 90degrees+

It probably would be possible with a long piece of flexi but there isnt a lot of room in the engine bay on the exhaust side for that!

personally im going to buy a few bends etc and fabricate my own

[TSM Locost]

Westfield 1600 cvh also fit 1800 cvh, usually 1 or 2 on ebay.
check out some xr3i xr2i tubular ones as well. I shortened the 2 pipes from the manifold and used 2 bends to bring out the side. cant find any pic's

[flyerncle]

I go with Mark on this one,it is possible to get a 90 deg bend but given the diameter of the pipe the radius will be large.
And by thin metal I mean thin.
45/90 deg bends in tube are available from most exhaust suppliers just look on the Bosal website and you will get an idea of what I mean and I think this will be the easyiest answer.

Good Luck.

[HandyAndy]

Adrian .... do you fancy selling the original cvh down pipe you made? pant pant

cheers
andy

[HandyAndy]

JUNK????? no no no no

ok thanks Adrian

andy