welding - Haynes Forums

26th September 2009, 08:30 PM

londonsean69 londonsean69 is offline

Senior Member

Join Date: Nov 2008

Location: Surrey/South London Border

Posts: 453

I gave them a couple of good tacks, then ground them down. IMO they are going to be welded on the other 3 sides anyway.

When tacking, I usually have the MIG set quite a bit higher than while welding. It gets the heat straight in without causing a massive blob of weld on the surface.

Sean

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 03:10 AM.