jigs

[andyuk697]

hi again
ive made the jig for the front lower wishbones as to book specs
i cut the 25mm seamless to lenth placed them on the plate put the tubes on the end mitred them measured them to lenth end to end
and now the holes on the plate dont line up with the holes in my jig to bolt the plate down i cant see what ive done wrong :s any ideas?

thanks Andy

[andyuk697]

hi all has anyone else had problems with the front lower jig see above post

thanks Andy

[Bonzo]

I seem to remember reading some of the missing posts & believe that the lower wishbone arm measurements are a tad over long to allow plenty of material for notching the mitres.

The first set I made needed a bit of trimming from my tubes

Provided the jig is made to the book measurements, trim away untill it is a good fit.
The wishbone will end up to the book spec.