Roadster roll bars

[flyerncle]

I get your point,Stay safe, stay at home and don't drive at all.

[mr henderson]

Originally Posted by flyerncle

I get your point,Stay safe, stay at home and don't drive at all.

Heck of a lot of accidents happen in the home, mind!

[flyerncle]

I knew that was coming !!!!!!!!!!

[georgenewman1]

i noticed that the roll bar didnt attatch to much, as a result i made the rear hoops of the body support out of 20mm x 3mm seamless tube and braced it down to the diff cage to add extra stiffness

[mark]

Im using a fibreglass rear end from saturn and this is where i anchored my rear roll bar stays, they are bolted in from underneath with m14 bolts through 6mm support plates plates.

Before anyone says it yes i did put one on the other side aswell

[georgenewman1]

how gooder fit are these rear ends. i have a prefabbed aly tank that sits about 1" in from were the skin would sit, willl this contact with the pannel??

[mark]

Unfortunately you need to modify the rear end a little to make them fit and a book spec fuel tank wouldnt work.

But a few simple mods gets them fitting perfect and they really look the part.