|
|
|
|
#1
25th November 2009, 11:04 AM
|
||||
|
||||
 Hi Yes you are right Andy, my little brain worked it out, if you look at the book page 63 last sentence it tell you that the longer arm goes to the front. on this basis the threaded bit will be pointing upwards pointing towards the car. Hope this helps!
__________________
Regards Axle 
|
|
#5
25th November 2009, 02:17 PM
|
||||
|
||||
hi, basically with the lower wishbone parallel to the floor the upper balljoint face should be paralell with the top of the mushroom this looks like the balljoint is pointing upwards but if you look at the upright fom the front you can see where the strut if it were there would be at a 90degree angle to where the balljoint is now and if the strut was there it would be leaning in at the top
hope this makes sense and helps Ray
|
|
#7
26th November 2009, 10:58 AM
|
||||
|
||||
|
apologies,
maybe i didn,t explain what i meant clearly, hangs head , tough few days  cheers andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
