dogwoods drawing will work. all i would change on it is the live from the ignition to the coil. rather than have it a constant live i would make it a switched live off the black wire on the igniton switch.
if you are feeling mad and just want to check the engine fires up then dump the ignition module and just put a pos and neg on the coil then start the engine. dont do it for too long though as it will end up making the coil bloomin hot.
these days i cant be bothered with distributors and all that muck. megajolt is the way forward.
have just about finished my cars electrics. have done a full custom loom with koso rx1n dash, megajolt with TPS and additional hard rev cut board, and electronic fuel pump supplying bike carbs. i like building cars but i like electronics more.
2nd December 2009, 02:09 AM
Threaded Mode