Rear Disc Brake Cable - Haynes Forums

		Haynes Forums > Haynes Roadster Forums > Running gear
Rear Disc Brake Cable

#12

6th December 2009, 12:33 PM

ozzy1

Senior Member

Join Date: Jul 2009

Location: perth,australia

Posts: 760

As flyerncle says put a slot into it to thread the cable through.You can heat up a piece of angle with blow torch and encourage

it to the required angle,or use a small offcut to pack it up to the required angle then weld fully.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 06:06 AM.