Wishbone profiles

[Bonzo]

Afraid I can't take any credit for this info

Tis hidden in the darkest depths of the forum but unless you type "Tube Mitre " in the search bar, it's diffiicult to find

Suprised that Ash didn't tell you about it...........I reckon he's holding back on you mate

[gingea1pom]

I have just gone out to the garage with my new paper profile and it is just spot on

Originally Posted by Bonzo

Afraid I can't take any credit for this info

Tis hidden in the darkest depths of the forum but unless you type "Tube Mitre " in the search bar, it's diffiicult to find

Suprised that Ash didn't tell you about it...........I reckon he's holding back on you mate

I think I have sapped Ash for information over the last month, you don’t see the pm’s that I send!


Cheers Ginge

[spud69]

Try this site, its the same thing but a bit more user friendly....

http://metalgeek.com/static/cope.pcgi

[Peter-C]

I've just spent an hour wasting bits of tube trying to work out by eye how to fit the roll bar cross brace. Then I remembered tubemiter. 2 minutes later absolutely spot on. Whoever wrote it, is a God !!

[squbti]

here´s what i used on my wishbones & it works great.DSC01121.JPG
cheers
samy

[flyerncle]

Hi Samy,I can see it is a die grinder but what are the ends.Emery ?

[squbti]

The grinder has a cone shaped top made of hard latex & cone shaped sand paper that just pops on . The one I used was an 80 paper .
cheers
samy

[flyerncle]

Thanks Samy