|
|
#2
16th December 2009, 05:45 PM
|
||||
|
||||
Chris recommends 0.8mm in the book, I know a couple of members are using 0.6mm wire. I can't see any issue with 1mm wire.
As i understand it the larger the diameter then the larger the current, meaning the hotter the metal will get, meaning you will need to put the welder on a lower setting to prevent yourself from blowing through. Have a go on some off cuts and see how it goes.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode