Cp 10 - Which way up?

[Enoch]

Hi folks, I see from the book that CP10 has two holes - one is 25mm from the end, the other is 31 mm from the opposite end. What I can't find in the text is which way up does it fit? It will obviously effect the height that the diff sits up so it must have been designed offset for a reason. Anyone know for sure?
Thanks in advance,
Enoch.

[gingea1pom]

Mate I posted the exact same question the other day and didn’t get a definitive answer, so, I have left them off and when I get the diff of my Sierra I will work it out and will then have the answer for others.

Cheers Ginge

[HandyAndy]

ooops , its been so long since i did those plates i can,t remember,
i,ll check the car in the morning and post info up,

cheers
andy

[gingea1pom]

Cheers buddy,

That would be two more plates on the chassis

[HandyAndy]

Originally Posted by gingea1pom

Cheers buddy,

That would be two more plates on the chassis

no prob,

have you found where cp24 goes ?????

i,ll get my coat
andy

[gingea1pom]

Oh Andy I’m way past CP24.

When I first saw the question “where does CP24 go” I made it my mission to find out.

Cheers Ginge

[tigmatt]

The 25mm end goes at the bottom. page 45 transmission dimensions

[HandyAndy]

Originally Posted by tigmatt

The 25mm end goes at the bottom. page 45 transmission dimensions

nice one Tigmatt,

andy

[HandyAndy]

Originally Posted by gingea1pom

Oh Andy I’m way past CP24.

When I first saw the question “where does CP24 go” I made it my mission to find out.

Cheers Ginge

there,s a few new builds started since that thread, hhmmmmm it,ll come up again i think

andy

[gingea1pom]

Tigmatt,

Well done that man that is great interpretation of the drawing.

It’s going on tomorrow.

Cheers Ginge