|
|
#13
10th January 2010, 10:03 AM
|
||||
|
||||
See, now you getting complicated.
 When I did mine I kept doing a bit then tested it, till I got about half the thread through. So when I tightened it up it pulled in snug without the thread bottoming out. Not sure, but think if you did it till the bottom was 16mm it may be too much. You will need someone that has done one recently to be sure.
__________________
. . David. Heaven, Warm days and Cool rides 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode