|
|
|
|
#1
30th January 2010, 09:08 PM
|
||||
|
||||
I will also be using these engine mounts, I also know that HandyAndy will be too., the engine mounts need to be motived to accommodate them though as they are not as big as the old ones.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting 
|
|
#2
30th January 2010, 09:30 PM
|
||||
|
||||
|
I will be using the same as well on an 1800 CVH
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now!  Build Pictures Build Thread
|
|
#4
31st January 2010, 12:22 PM
|
||||
|
||||
|
The land rover rubbers are the best to go for, they are cheap and give a nice firm support for the engine. The only problem is you shall have to remake the cvh engine brackets to suit.
A lot of people have had trouble with the sierra rubbers being perished so i think it would be wise for all builders to change their rubbers as part of the build. AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#5
1st February 2010, 12:48 PM
|
||||
|
||||
|
I bought mounts from car builder solutions, they do a nice range that aren't expensive so you may find a set to suit you without modifications.
__________________
Check out my Build Blog www.samsv8locost.blogspot.com And here's all my build photo's on a picasa web album http://tinyurl.com/5tbtm46
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
