|
|
#14
8th February 2010, 11:19 AM
|
||||
|
||||
Also. the mondeo shafts run in line with the back edge of the engine. So with the driveshafts in line with the hubs would mean the engine is sitting in the front frame at the nosecone, this would probably put too much weight over the front of the car.
Look at this picture and imagine the engine being turned 90 degrees and centraly located where the front rails are. That's prety much where it will have to be.  TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders Last edited by twinturbo : 8th February 2010 at 12:28 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode