|
|
|
|
#1
18th February 2010, 09:38 PM
|
||||
|
||||
Quote:
yes I know I have made 1 or 2 chassis in the past 5 months. I just thought it might help some one out.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 
|
|
#2
19th February 2010, 02:15 PM
|
||||
|
||||
|
PMSL I can't see the weld taking to the compost, think you might get a bit of pirosity
 On a slight tangent but are all the CP's fully welded?
|
|
#3
9th May 2010, 09:27 PM
|
||||
|
||||
|
do you fully weld ss1 to cp11 and the rails or just leave it tacked?
|
|
#4
9th May 2010, 09:41 PM
|
||||
|
||||
|
I stitch welded mine James
Welded 1/2" missed 1" on the outside, on the inside I put in 1/2" stitches in the midde of the 1" gap. It will probably warp like hell if fully welded  I used a piece of 1.6mm sheet for mine, mainly because that's what I had here in stock .
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie  www.roadster-builders.co.uk
|
|
#5
9th May 2010, 10:16 PM
|
||||
|
||||
|
i welded the plate on the side then just tacked it bit by bit worked a treat. think there are some pictures of doing it in my photo bucket somewhere
i boxed mine in both sides as it meant one less bit to edge trim for iva 
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/ Last edited by AshG : 9th May 2010 at 10:18 PM.
|
|
#6
10th May 2010, 07:26 PM
|
||||
|
||||
|
what thickness cp11 did you use ash?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
