Hello

[mr-p]

Update

Last few sundays have seen the following:

Pedals, have all the pedals & mounts made.

.

Going to wait for the bushes before I weld it all up.

Wishbones cut & profiled, all done bar the lower fronts, & 1 Back cross member.

.

I am nervous about welding them as they are very visable & i want the welding spot on. Might get them tig'd if it is not too much ££.

Rear End, did this today bent the tubes using a gate hanger & granite post on the entrance to my house turned out pretty good.



Also done the cross member for the roll bar, managed to make it short so it is about 120mm from the rail below it - anybody know if this is OK for IVA. (must read manual).

For the roll bar back tubes, is it right that you now need 2 bolts fixing it or it has to be welded?? Thought this was the outcome of Ash's test?

Next will be engine fitment & mounts.