Zetec Clutch release bearing !!

[Bonzo]

Hey Dennis .... No worries mate

I have certainly had a few of those moments during the build

Did connect the engine & box this morning ( Was going too anyways )
With the original release bearing fitted, there isn't a lot of throw .... Did connect the cable & to my surprise it did just about diss-engage before the bearing arm hit the bell housing !!

But that is far from ideal and the chances are, once the friction plate has bedded in there will certainly be a bit of cluch drag

Rang one of the other local motor factors this afternoon, may have had a result.
They are able to order from QH direct, he checked the computer & the CCT133 bearing is listed as still available from stock.
I'll pop in tomorrow & get one ordered