|
|
#11
9th May 2010, 09:41 PM
|
||||
|
||||
I stitch welded mine James
Welded 1/2" missed 1" on the outside, on the inside I put in 1/2" stitches in the midde of the 1" gap. It will probably warp like hell if fully welded  I used a piece of 1.6mm sheet for mine, mainly because that's what I had here in stock .
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie  www.roadster-builders.co.uk 
|
|
#12
9th May 2010, 10:16 PM
|
||||
|
||||
|
i welded the plate on the side then just tacked it bit by bit worked a treat. think there are some pictures of doing it in my photo bucket somewhere
i boxed mine in both sides as it meant one less bit to edge trim for iva 
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/ Last edited by AshG : 9th May 2010 at 10:18 PM.
|
|
#13
10th May 2010, 07:26 PM
|
||||
|
||||
|
what thickness cp11 did you use ash?
|
|
#15
30th January 2011, 07:21 PM
|
||||
|
||||
|
Quote:
cheers andy
|
|
#17
30th January 2011, 08:31 PM
|
||||
|
||||
|
Quote:
I think you are going to have your hands full this coming week,  cheers andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
