Seat belt mount heght

[Bonzo]

I seem to remember reading about that in the manual quite some time ago .... A minimum height of 400mm above the seat datum point is in my mind for some reason

I had another read the other week & could't find that section again

Best double check first .... As said, tis only a measurment floating about in my head & all of you folk know how sick my mind is !!??

[drury318]

I`ve just checked and it`s in Section 31 seat belts on page 3 of 8, it must be 450mm above the ref point, but please read about the ref point as it doesn`t just mean 450mm high, there is a diagram showing you how to determine the ref point. Cheers, Dennis

[Enoch]

Hmmm, my downloaded copy of the manual does not have a section 31, the only section it has that has anything to do with seatbelts is section 19 and it has no picture or mention of a reference point. Starting to think I have a dodgy download, will get another from the Vosa site.
The only diagram I have of the seat shows the headrest height at 753mm above the seat squab.
Thanks for the replies chaps.

[Enoch]

Just downloaded a new copy, it is indeed 450 above reference point. There is no requirement for distance between upper fixings but there is for lower fixings which have to be between 350 and 500mm apart. My upper fixings will be about 75-100mm above the minimum so I should be fine. Happy days

[Bonzo]

Originally Posted by Enoch

Hmmm, my downloaded copy of the manual does not have a section 31, the only section it has that has anything to do with seatbelts is section 19 and it has no picture or mention of a reference point. Starting to think I have a dodgy download, will get another from the Vosa site.
The only diagram I have of the seat shows the headrest height at 753mm above the seat squab.
Thanks for the replies chaps.

Glad I am not the only one !!

I thought I was going off my trolley, Knowing I had read that section & then unable to find it again for another read

Probably reading an online version at the time, meethinks it best that I download a new copy as well

My memory was 50mm out .... That's about parr for the course with me .... My mental tape measure needs replacing

[RAYLEE29]

Hi, before you weld anything!
there is a dimension for width of the top mount from the centreline of the seat.
not sure if it only applies to a lap/diagonal belt or includes harnesses too
gonna have a quick scan of the regs now
Ray

[Enoch]

Hi Ray, I couldn't see anything, only a dimension for the bottom mounts.
Let us konow if you find otherwise.
Cheers

[RAYLEE29]

Hi, section 31 page 2 no. 17
"A Lap/diagonal belt "effective upper anchorage" location must be at least 140mm from the longitudinal centre line of the seat (see note 14)."
knew id seen something somewhere.
I read it as only applying to normal seat belts and not harnesses but ive spaced mine accordingly as i may use some ordinary belts or harnesses.
so ive put in two top mounts per side and may put an extra one near the floor below the top mount so i can use an inertia real belt as i find harnesses a pain to use
anyway there it is
hope it helps
Ray