Where's this pipe go then???

[Enoch]

Hi TT, thanks for that. I thought the crank breather would need to go to the manifold. Good point on the IVA issue. Will have to have a think about that. I have used one of those conical high flow filters so there is nowhere to connect the cam breather to. Do you reckon it would be ok to pipe it to where the servo pipe used to connect on the inlet manfold? I have a vacant hole there so may as well use it if I can.
Dave.

[mark]

I had an oil catch tank with a breather filter for iva and there was no comments about it. If you do use a filter make sure you use a catch tank so any oil residue doesnt end up clogging the filter and raising the pressure in the crankcase which may cause some premature oil leaks.

[flyerncle]

Flame traps are a good idea in any breathing system attached to inlet manifold's as a backfire could set fire to any vapour in the crankcase.
As Mark stated a catch tank is a good idea.