|
|
#2
8th July 2010, 12:40 PM
|
||||
|
||||
i used 6 strategic rivets along the top one at each end and 1 on each side of the bend cut lines.
i used 4 rivets on the side at the back going into the sb rails which you cant see once the wheel arches are on. on the bottom edge of the panel i did a rivet through the side panel and floor every 2.5inch. everything was stika flexed and after nearly 1500miles there are no signs of anything coming loose.
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode