Steering column support frame

[David_17]

Great. Thanks for the help. Do both CP14s go in the diff area?

Also anyone else had problems with steering wheel or seat height?? Or are you all tall?

[james3004]

I think you only need 1 cp14 for the handbrake

[les g]

CP24
front of engine bay
where the engine rails meet the outer rails
they are like a fillet to reinforce the join
br1-br8 and br2-br9
cheers les g

[ozzy1]

cp 14 - 1 off req to locate handbrake cable(slot both holes to slide cable in easily)
cp9 - 2 off ( square with square cut out & hole in) roll bar support plates
cp8 2 off fuel tank supports
cp25 2 0ff (larger triangle) below cp9 to strengthen cp9 supports
cp24 as les g said

[HandyAndy]

CP9 & CP25 only needed if you are fitting an ali rear tub, but if fitting a GRP tub you,ll need an extra frame layout to attach it to ( see other thread/posts about the layout).

cheers
andy

[David_17]

Thanks for the help guys, spent ages today holding the little triangle all over the chassis, then finally found it!

My grinder packed in this afternoon, but when i got home found that it was just a wire had snapped inside the flex. So can crack on again tomorow.

By the end of tomorow i hope to have the rest of the wishbones cut (and possibly weld one or two) and get the suspension brackets and seat rails welded on the chassis.

Then i'm waiting to get some M8 nuts for the roll bar mounts (i've only got stainless ones at the moment) which means i can get the back end of the chassis finished, then some 7/16 unf nuts for the seatbelt mounts (the shop that sells them is only open mon-fri 9-4.30 when i'm ususally at work)





After that, the chassis is about finished, besides engine mounts and headlamp brackets