|
|
#4
26th July 2010, 07:16 PM
|
||||
|
||||
Yea, you're on the same wave length as me, just it's hard for me to picture as i haven't got the nosecone yet.
 Could always cut the end of the tube the correct angle as the nose cone (and weld the nut to the same angle), then just use a bolt that is just long enough to go through the nuts if that makes sense. 
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode