Cp10 problems.

[baz-r]

to get cp10 to fit scribe a line 25 mm from the bottom (hole center) then do the same on the back face of the 2 vertical tubes of the seat back trim the top end to suit with the two scribed lines in line
i made them 4mm shorter all removed from the top end of cp10 to get the hole center 25mm above the base tube as shownin the diagram
hope that clears it up

[KenK]

Oh b.....cks, just checked, i have put one the wrong way up!! Which is the correct way please before i get Mr Angry Grinder out!

Cheers
Ken

[ozzy1]

25mm offset hole at the bottom.

p45 section A-A

[KenK]

Cheers mate, grinder successfully deployed!

[les g]

why not just redrill the holes in the right place
you could also weld up the old holes if you need too
cheers les g

[leroybrown911]

Ok, just come across this problem myself. Am I right then taking the excess material off the top of CP10 and therefore maintaining the 25mm edge distance, and correct positon/height of diff from the table?

[ozzy1]

Yes take the excess off the top to maintain the 25mm from the bottom.