Chassis Plate CP24

[antonia800]

Originally Posted by HandyAndy

I,m a little confused here.... in my book , CP25 is correctly identified to fit on the rear tub upright ( RP3) on both sides of the chassis.

CP24 actually goes at the front of the chassis in the joint where BR1 & BR8 .....BR2 & BR9 meet, its a support plate for the lower rear front wishbone bracket .

I Thought I,d add this to help clarify.... There are 2 CP25 plates for the rear of the chassis as in the diagram you mention.

There are also 2 CP24 plates that are positioned at the front of the chassis as I have described,
Tho , you are correct, there is no text in the book to where CP24 plates are located.

hope this helps.

cheers
andy

i have filled in this area br2 br9 meets top to bottom as i thought it was an area of likely corrosion salt, water, etc but whilst i totaly agree with you Andy cp25 fits on the outside of rp3 and not the inside as shown in diagram 4.14 page 43 so i fitted cp24 between rp2 and rp3 as in the left hand side of this diagram (4.14) yet another failure of discription !!!!!!!!!!!!!!!!!!!!!!!!!!!!