Drag link nut covers

[mr henderson]

Split rubber tube around the nut and held in place with cable clips went through IVA (Leighton Buzzard) recently with no comment.

[Bonzo]

Gland's that's the fellas

I guess a small rubber boot would also do the job .... Something similar to the ones fitted to the Escort/Fiesta Gearbox selector shaft ?

Ash's tester wanted to see a covering similar to something that resembled a factory fitted part

I do know that other cars have passed IVA with the usual shrinktube or rubber sleeve held on by wire ties

I am keeping my fingers crossed that I will be well enough to travel up to Exeter this year Gus

[DaddyA]

I'm going to try electrical amalgamating tape, it's quite thick and covers well and doesn't come off easily.

I'll give it a try and see what happens

[David_17]

Originally Posted by DaddyA

I'm going to try electrical amalgamating tape, it's quite thick and covers well and doesn't come off easily.

I'll give it a try and see what happens

I was thinking that, or sillicone tape.

[twinturbo]

Ash may correct me, but the tester said that the covering should be removeable for checking and adjustment of the nut without damage to the covering.

The inspector could not check the nut without damage and the car would then fail on no cover.

I think ???

TT

[DaddyA]

So if people have used heat shrink (ie for steering rack), I take it they haven't shrunk it?????

Just asking and looking for solutions - getting to that stage.

[mark]

Another vote for cable glands that fit nice and tight, you can pull them back to make adjustments and push it back again

Also its as permanent as anything else you could use, as it would only come off if you cut it of or dissasemble the tre etc

Mine went through iva with cable glands and there was no comments