|
|
|
|
#1
23rd August 2010, 09:01 PM
|
||||
|
||||
Ash may correct me, but the tester said that the covering should be removeable for checking and adjustment of the nut without damage to the covering.
The inspector could not check the nut without damage and the car would then fail on no cover. I think ??? TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders 
|
|
#2
23rd August 2010, 10:28 PM
|
||||
|
||||
|
So if people have used heat shrink (ie for steering rack), I take it they haven't shrunk it?????
 Just asking and looking for solutions - getting to that stage.
|
|
#3
24th August 2010, 07:30 PM
|
|||
|
|||
|
Another vote for cable glands that fit nice and tight, you can pull them back to make adjustments and push it back again
Also its as permanent as anything else you could use, as it would only come off if you cut it of or dissasemble the tre etc Mine went through iva with cable glands and there was no comments
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
