|
|
|
|
#1
25th August 2010, 10:41 AM
|
|||
|
|||
Yea it was all cut to book spec which is why i couldn't understand why it had happened?
I am tempted to leave it and use alloy sheet to correct the problem when in comes to fitting the scuttle?
__________________
Building 1800 Zetec Roadster 
|
|
#2
25th August 2010, 11:29 AM
|
||||
|
||||
|
Sorry but you need to start off with a good square and flat chassis otherwise you're going to come across loads of problems later on and 36mm is an awful lot. If its only tacked then i would check your build table is marked out correct, HAndy may have some spare templates left, and remake it. Or you could bring it over to the North East and i'm sure me and HAndy could remedy the problem and jig on the suspension brackets so that you have a good base to start from.
All the Best....AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#3
25th August 2010, 12:27 PM
|
|||
|
|||
|
The chassis is nearly complete. There is only one rail out of place and it is fully Tig welded in place. All other rails are fine.
__________________
Building 1800 Zetec Roadster Last edited by nnrouty : 25th August 2010 at 12:49 PM.
|
|
#4
25th August 2010, 12:57 PM
|
|||
|
|||
|
36mm is well over a tube width. How on earth did you manage to do that?
__________________
Sean
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
