|
|
#2
20th October 2010, 12:25 PM
|
||||
|
||||
If the steel is not ERW it will be Hollow Rolled Section or known as black by most production welders. Theres nothing wrong with using it for a chassis but it will very dirty to work with, it's not known as black for nothing. It will be at least 2mm wall so you might want to put a weld prep or 45' camfer on the ends if using a hobby MIG welder.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode