|
|
#4
20th October 2010, 08:22 PM
|
|||
|
|||
hi david
2. Cut your green wire and join one end to one of the gearbox wires and the other to the other one. It's just a switch. i dont quite understand (probably obvious) my loom has the single green wire dedicated for reverse switch. one side is at rear for light itself and then other side just leads out of loom to connect to reverse switch with regards to cap, does it matter which side connects to where? thanks steve 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode