|
|
#11
24th October 2010, 10:24 PM
|
||||
|
||||
It´s just that I have the first of 3 tests on the car comming up in one week & I need to sort out theses problems before that if I can I´m trying to keep it as low as posible but I´d like to have some good clearance at the same time .
has anyone needed to have spacers under the motor mounts? Is that something i should try? The way I see it even if I had 100mm in the front i would still have 65-70mm under the sump & gearbox  Thanks Samy 
|
|
#12
24th October 2010, 10:29 PM
|
|||
|
|||
|
Try raising it Samy, Do you have speed bumps where you are (traffic calming).
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#13
24th October 2010, 10:40 PM
|
||||
|
||||
|
I´ll give it a go tomorrow, we dont have any speed bumps here or not alot anyway but we do have alot of roundabouts & also people can get perments to put out flower beds/boxes in the street to slow down trafic
  most of the time drivers go faster because they think its fun to zigzag between the boxes, so that shouldnt be a problem with the sump anyway.cheers Samy
|
|
#14
24th October 2010, 11:20 PM
|
|||
|
|||
|
Sounds like fun,good luck.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
