|
|
|
|
#1
26th October 2010, 07:11 PM
|
||||
|
||||
Sounds simple enough, pics are always good tho if you have one
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. 
|
|
#2
26th October 2010, 07:18 PM
|
|||
|
|||
|
Actually, I only used a clevis for the throttle cable, the clutch cable is a capri one that has an end with a 6mm hole through it. Originally I was going to use another cable but found the Capri one much easier to work with. I will see if I can find a decent photo.
Enoch
|
|
#3
26th October 2010, 07:19 PM
|
||||
|
||||
|
I've just ordered a capri cable, a pic would be great
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#4
26th October 2010, 07:21 PM
|
|||
|
|||
|
Depends on what type of clutch cable you intend to use,some have a round nipple the capri has a round eye as does mine and I intend to weld another piece to the pedal and sandwich the eye in the middle with a hard steel pin.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
26th October 2010, 07:49 PM
|
|||
|
|||
__________________
http://www.flickr.com/photos/29404787@N03/ http://www.flickr.com/photos/41021922@N03/ http://www.flickr.com/photos/56936222@N04/ http://www.flickr.com/photos/79486076@N06/ Finished my roadster after 5 years! Number 27! Last edited by Spikehaus : 26th October 2010 at 07:55 PM.
|
|
#6
26th October 2010, 07:54 PM
|
||||
|
||||
|
Perfect, thanks. Is your brake piston just an m8 bolt with the head cut off?
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#7
26th October 2010, 08:13 PM
|
|||
|
|||
 ]If you use a half thread bolt and clean up the end where you remove the head, it should do the job!
__________________
http://www.flickr.com/photos/29404787@N03/ http://www.flickr.com/photos/41021922@N03/ http://www.flickr.com/photos/56936222@N04/ http://www.flickr.com/photos/79486076@N06/ Finished my roadster after 5 years! Number 27! Last edited by Spikehaus : 26th October 2010 at 08:26 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
