Any sheetmetal workers here - after some advice.

		Haynes Forums > Haynes Roadster Forums > Bodywork and interior
Any sheetmetal workers here - after some advice.

10th November 2010, 11:28 PM

davidimurray davidimurray is offline

Senior Member

Join Date: Jan 2009

Location: Near Cardiff

Posts: 742

Thanks Talon

I did wonder if I was over doing things a bit! THis is how far my experiment got on a piece of scrap -

How are you planning to put a radius between your trim piece on SS1 and the side sheet?

Cheers

Dave

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 09:48 AM.