Fibreglass - one for Spud

[spud69]

Hello David,

The resin used is Encore 30 which is a Polystyrene based resin rather than Epoxy. The data sheets for the product talk about the material in its pre-cured state and say that the auto - ignition point is 490deg. However the resin is a lot more stable once cured, especially since the actual glass is non-combustible.

As you say the exhaust on my orange car is very close to the side panel, 5mm, and has caused negligible damage. The side repeater has suffered a lot more. A comfortable clearance i say would be 20mm, in my experience.

Hope that helps....AndyH